Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Why San Bernardino Homeowners Choose Tremron Construction
San Bernardino Tremron service comes down to one thing: hardscape that survives inland heat, expansive clay soil, and Santa Ana wind seasons without failing at the base. We’re an independent Tremron installer serving San Bernardino and the surrounding Inland Empire, and we work with Tremron pavers, retaining wall block, and coping every week. We buy Tremron products directly, we don’t answer to Tremron as a dealer or authorized rep, so our recommendations on base depth, drainage, and joint sand reflect what actually holds up in this climate, not what a manufacturer’s spec sheet assumes. If you’re researching Tremron for a paver driveway, patio, or retaining wall in San Bernardino, call us at (855) 382-3257 for a free estimate and we’ll tell you what your project actually needs.
Why Trust Toolbox Contractors for Your Tremron Construction?
Tremron makes a solid paver. But a paver is only as good as what’s under it. That’s the thing most San Bernardino homeowners don’t hear until the driveway starts rocking or the wall starts leaning two summers in. We’ve torn out enough failed Tremron installations across this city to know that the product wasn’t the problem. The base was. Norm Castellano grew up in Tremron service in Muscoy territory just northwest of San Bernardino and cut his teeth at San Bernardino Valley College’s construction technology program before spending close to two decades on residential framing, roofing, and full hardscape rebuilds across the Inland Empire. When he runs a Tremron job now, he specs the base for San Bernardino’s expansive clay and caliche-heavy subgrade first, then picks the paver. That order matters. We’re a full-scope general contractor, so the same crew that lays your Tremron patio can also handle the roof, the fence, or an ADU on the same property. One contractor. Every phase. For Tremron work specifically, that means we’re not a paver-only shop guessing at drainage because nobody told us the downspouts empty right where the patio edge sits. We see the whole site.
Styles & brands we work with







Common Tremron Construction Problems We Fix in San Bernardino
- Efflorescence bloom on Tremron tumbled pavers. That white, chalky haze isn’t a defect. It’s moisture wicking up through the paver and carrying salts to the surface. In San Bernardino, we see it most often on Tremron Olde World Wall caps and tumbled paver blends when the base doesn’t drain and the joint sand stays wet through winter. The fix is almost always drainage correction and proper polymeric sand, not a coating that traps moisture and makes it worse.
- Joint sand washing out and pavers shifting. Tremron Holland Stone and Olde Towne pavers with shallow base over San Bernardino’s expansive clay are the classic failure. The clay absorbs winter moisture, swells, and pushes the pavers out of plane. Then summer heat shrinks the soil and the pavers rock. By the time the joints empty out, the base was already too thin. We typically pull the field, deepen the graded aggregate base, and re-set the salvaged pavers.
- Retaining wall block leaning or bulging. Tremron Olde World Wall is a tumbled, modular block that looks great on paper but leans hard when someone stacked it without geogrid or proper gravel backfill. We’ve rebuilt walls in San Bernardino’s foothill neighborhoods where the builder treated it like a garden edge. A four-foot wall holding back clay soil is a structural element, not a decoration. It needs geogrid, clean drain rock behind the block, and a proper toe.
- Color fade and surface scaling on darker Tremron blends. Inland sun is brutal on unsealed pavers, and darker Tremron blends like the Mega Olde Towne in charcoal tones absorb serious heat. We see scaling most often when someone sealed with a cheap film-forming product that trapped moisture. Tremron pavers need a breathable sealer or no sealer at all, plus joint sand that doesn’t break down into dust under UV.
- Bullnose coping cracks on pool decks and seat walls. Tremron Bullnose coping is a common choice for raised patios and pool edges in San Bernardino, but the coping is only as stable as the mortar bed under it. On expansive clay, the slab moves and the rigid mortar cracks the coping units. We set these over a flexible bond and proper control joints so the movement has somewhere to go.
Tremron Parts & Our Repair-vs-Replace Approach
When we repair Tremron work, we source genuine Tremron pavers, wall block, and cap units so the color lot and dimensions match the existing field. Tremron runs production lots that vary slightly in tone, so we pull a sample from your existing hardscape and match against current inventory before ordering. We pair those units with contractor-grade polymeric joint sand and graded aggregate base, not the box-store bags that break down under San Bernardino’s summer heat. For most failures, we take the honest route: if the base is shot, re-laying pavers over bad subgrade just repeats the problem. A partial tear-out and rebuild beats patching every time. But if the issue is isolated, say a cracked cap unit or a sunken paver section where a downspout washed out the edge, a targeted repair makes sense. Call (855) 382-3257 and we’ll tell you which one you’ve actually got.
Our Tremron Service Process – Step by Step
- 1
Site and subgrade diagnosis. We start by checking what’s under the Tremron, not just what’s on top. In San Bernardino that means probing for clay, checking drainage patterns, and looking at how water moves on the site during the rainy months. A paver failing at the base shows symptoms before the surface moves.
- 2
Repair or rebuild scope. If the base is sound, we do a surgical repair: remove affected units, correct the bedding layer, re-set with matched Tremron pavers, and joint with polymeric sand. If the base failed, we pull the field, grade and compact the subgrade properly, install a deeper aggregate base, and re-set.
- 3
Tremron-specific installation. We follow the manufacturer’s pattern and spacing specs, but we adjust base depth and drainage for San Bernardino clay. No two sites are the same, and the north foothill side of town drains differently than flat downtown blocks.
- 4
Joint finishing and test. We sweep in polymeric sand, activate it, and check that water sheets off the surface instead of pooling. For retaining walls, we verify drainage behind the block and check for any lean before we leave.
- 5
Warranty and follow-up. We stand behind our hardscape work with a written workmanship warranty. If a joint blows out or a paver shifts, you call us, not a third party.
See the difference
Before
After
Before
After
Before
AfterTremron Products We Service & Install in San Bernardino
We service and install the full Tremron hardscape lineup that’s common in San Bernardino yards: Tremron Olde World Wall for tumbled retaining walls and seat walls, Holland Stone and Olde Towne pavers for driveways and walkways, Mega Olde Towne and Brittany modular pavers for larger patio runs, and Bullnose coping with matching cap units for pool edges and raised planters. We stock base aggregate and polymeric sand locally so we’re not running back and forth across the Cajon Pass to get material. For Tremron pavers we order per project to match your existing color lot, which matters more than most homeowners realize until the new section doesn’t match the old one.
We Also Service These Brands
Tremron is one of 50+ vetted material brands we work with across every phase of a project. The same crew that rebuilds a Tremron paver driveway can also install KraftMaid cabinetry in the kitchen, Cambria or Silestone countertops, and Kohler fixtures in the bath. We’re a full-scope general contractor, so your hardscape doesn’t have to be a separate project from the rest of the house.
FAQs – Tremron Construction Service in San Bernardino
Yes, in most cases we can match the color close enough that the repair blends from standing height. Tremron production lots vary slightly in tone over time, so we pull a sample from your existing field and match against current inventory before ordering. That said, if your pavers have been in the San Bernardino sun for ten years, no new paver will match perfectly day one. The repair settles in within a season or two. Call (855) 382-3257 and we’ll assess your specific paver color lot before you commit to a partial repair.
Because re-stacking the block doesn’t fix the backfill or the missing geogrid. A Tremron Olde World Wall that’s leaning once will lean again unless you pull the block, install clean drain rock behind it, add geogrid layers tied back into the slope, and rebuild on a proper base. We see this constantly in San Bernardino’s foothill neighborhoods and Tremron in Highland areas where clay soil holds water and pushes against the wall from behind. The wall itself was never the weak point. Call (855) 382-3257 and we’ll tell you what your wall actually needs.
Sealing can help, but it won’t fix the white haze if the cause is moisture wicking up through the base. That efflorescence bloom on Tremron tumbled pavers comes from water moving through the paver and carrying salts to the surface. If we seal over the top without fixing drainage, the sealer traps the moisture and the bloom gets worse. When sealing is the right call, we use a breathable product that lets moisture escape. The fix starts with drainage and base prep. Call (855) 382-3257 to schedule a site look.
Yes. Tremron pavers are concrete units designed for hot climates, and San Bernardino’s 100°F-plus summers don’t crack them on their own. What fails is the base under them when expansive clay shrinks in the heat and the unsupported paver flexes. The paver then cracks from movement, not from temperature. A properly compacted aggregate base solves the actual failure mode. The pavers themselves are up to the climate.
For a Tremron paver driveway in San Bernardino, we spec a minimum of 6 to 8 inches of compacted aggregate base over properly compacted subgrade, with deeper sections where the clay is expansive or the grade is too flat for drainage. Driveways take vehicle load, so the base is doing the structural work. The pavers are the wearing surface. Anyone quoting you a shallow base to hit a lower price is setting you up for a driveway that rocks in two summers. Our paver driveway installations in San Bernardino run $7,000 to $18,000 depending on size and site prep. Call (855) 382-3257 for an exact quote, estimates are free.
How much does Tremron construction cost in San Bernardino?
| Service | Price Range |
|---|---|
| Paver Driveway Installation | $7,000 – $18,000 |
| Paver Patio Installation | $3,500 – $11,000 |
| Driveway Replacement | $5,000 – $14,000 |
| Driveway Sealing | $250 – $700 |
Exact pricing depends on the size of the field, existing base condition, drainage work needed, and Tremron paver style you pick. Call (855) 382-3257 for a line-item estimate, and we’ll walk the site before we give you a number.
Book Your Tremron Service in San Bernardino, CA
Tell me what you’ve got and I’ll tell you what it actually needs. Call Toolbox Contractors at (855) 382-3257 to schedule your free Tremron estimate in San Bernardino or Tremron repair in Loma Linda. We’ll diagnose the base, match your pavers, and give you a written line-item quote.
Written by Norm Castellano, Owner at Toolbox Contractors, serving San Bernardino and the Inland Empire.